Three steps to turn white background into black and create a dramatic effect

You may also like...

11 Responses

  1. james says:

    can’t figure this tutorial out.. its kinda confusing the way its written..

  2. Srecko says:

    Nice, thanks!

  3. Stephan Salt says:

    Hello there, i was testing out, bloody brilliant, but the last part (step three) is highly confusing. Could you say it again, but in dummie was so i can understand it.

  4. vertigoelectric says:

    Didn’t seem to work. Changing the duplicated layer to “color” mode didn’t do anything at all.

    Also, based on your example images, couldn’t you just invert the original and then change the hue?

    • David says:

      Your way is much better, although I added an extra step. Some of my original image was black already, and inverting made them white. I simply duplicated the original then changed the Blend Mode to Darken so that it would put the black back in without darkening the image like a Multiply would. Turned out perfectly. Your way was much better, so thank you vertigoelectric!

  5. vertigoelectric says:

    Take a look at this picture:

    All I did was take the example image above, drag it directly from this page into Photoshop, invert it, and then adjust the hue by +180. It is a tiny bit brighter than the original, but surely that could easily be adjusted if necessary.

    All of those other steps seem confusing and unnecessary.

  6. jmac says:

    Absolutely amazing.. huge creative effect .. great work!!!!

  7. korolov says:

    Didnt work for me :(

Leave a Reply to jmac Cancel reply

Your email address will not be published. Required fields are marked *